Operation; A) Installing The Receiver Aerial Cable; B) Inserting Batteries/Rechargeable Batteries Into The Transmitter; Putting The Transmitter Into Operation - Reely Rhino II Bedienungsanleitung



8. Operation

a) Installing the Receiver Aerial Cable

Now remove the car body. Remove the car body splints and take off the body upwards.
Unroll the aerial cable completely and smoothen
it carefully. Then insert the aerial cable through
the attachment at the vehicle from below and then
through the included aerial tube.
Plug the aerial tube into the respective holder at
the vehicle (see arrow in the figure on the right).
Let any excess aerial cable protrude loosely from
the tip of the aerial tube.
To more easily thread the aerial cable through
the holder, we recommend removing the battery
holder. For this, turn out the four screws that has-
ten the battery holder to the chassis.
Make sure that the aerial cable does not protrude into the drive or touch the cardan shaft! It is normally
sufficient to slightly tighten the cable or fix it in place with a cable binder. Never shorten the aerial cable!
Never roll up the aerial cable! This greatly reduces the range!

b) Inserting Batteries/Rechargeable Batteries into the Transmitter

Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Ob-
serve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment.
Observe the enclosed operating instructions for the remote control system.
c) Putting the Transmitter into Operation
Switch on the transmitter and put the trimming for steering and driving into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection. Please also note the
operating instructions of the remote control system.
33