Reely Rhino II Bedienungsanleitung Seite 46

The vehicle doesn't drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
Steering or driving motions opposite to movement of steering wheel and transmitter throttle/brake lever
• Put the reverse switch for steering or the drive at the transmitter in the right position.
• If the brushless motor is disconnected from the speed controller and wasn't reconnected, the two cables may have
been swapped.
The steering is not functioning or is functioning incorrectly, steering lock too slight on the vehicle
• If the transmitter offers a dual rate setting, check it (see operating instructions for the transmitter). If the dual rate
setting is too low the steering servo will no longer react.
• Check the steering mechanism for loose parts, check e.g. whether the servo arm is correctly fastened to the servo.
46