Reely Rhino II Bedienungsanleitung Seite 40

Set alignment for the front wheels:
For the front axle, alignment can be set by turning the steering knuckle arm (A). Because it has a left and right hand
thread at either end, it does not need to be dismantled to be adjusted.
Turn both steering knuckle arms evenly (left and right front wheel). Otherwise, you need to adjust the trim
of the transmitter (or even change the steering servo control by adjusting the servo rod (C).
The axle leg has several attachment points (B)
for the steering knuckle arm, which are used for
changing the turning angle of the front wheel
(Ackermann angle).
The manufacturer already selected the best set-
ting. Therefore, you should not change it.
Set alignment for the rear wheels:
The alignment for the rear wheels is set by the
so-called tie-in-block.
This is a plastics part attached to the rear differ-
ential (see arrow in figure on the right).
The two metal axles holding the lower transverse
links are attached to the outer holes of the toe-in
block.
A toe-in block with a different distance between
these two holes can be used to adjust the toe-in.
If the vehicle comes with a plastics past with additional toe-in blocks (see figure on
the right), these can be used to change the read wheel toe-in.
The alignment of the rear axis of your model vehicle has relatively little effect on
driving behaviour of your model vehicle. Replacement of the toe-in block is therefore
only relevant for professional drivers.
40
A
B
C