Operation; Switching On And Off; Operating Instructions - FLORABEST FGH 710 A1 Originalbetriebsanleitung

When assembled correctly, the
handle ends point away from the
equipment front with the ventila-
tion slits (see 7).
4. Fasten the mains cable with the
cable clips supplied:
- Large cable clip (3a) above the
cross-plate
- Small cable clip (3b) at the
frame tubing.

Operation

Observe noise-abatement laws and
local by-laws.

Switching on and off

Note: Before switching the tool
on, make sure that the tool is not
touching any other objects and
hold it firmly in both hands.
1. Plug the tool into the extension ca-
C
ble.
2. Loop the end of the extension ca-
ble and hang it onto the cable ten-
sion relief (16) to ease the tension
on the cable.
3. Plug the tool into the mains.
4. Hang the extension cable onto the
belt clip (12) and fasten it to your
trouser belt.
5. To switch on, press the safety re-
lease catch (17) and then squeeze
the dead-man lever (18). Release
the safety release catch (17).
The tines (
tate and dig themselves into the
earth.
6. To switch off, release the dead-
man lever (18).
A
11) will begin to ro-
Warning! The tines will continue
to turn for a few seconds after
the tool has been switched off.
Do not touch the rotating tines –
injury hazard!

Operating instructions

Always keep a firm grip on the
tool with booth hands and watch
your feet.
The tines may cause an acci-
dent.
Be careful while moving back-
wards – danger of tripping!
Do not touch the gearbox, as it
may become hot during opera-
tion – danger of burns!
To avoid damage to the tool:
• Never lift or drag the tool with the
motor running.
• Lift the tool while moving it over
hard surfaces such as tiles or
steps.
Switch the tool off after working with
it and for transport; disconnect from
the mains and wait for the tines to
stop moving.
• Walk the tool through the soil
at normal pace and in a line as
straight as possible.
• Always work away from the
mains socket. Make sure that
the cable is kept well away from
the working area. Hanging the
cable into the belt clip included in
the package will help.
• Overload protection: The mo-
tor will cut out immediately if
overloaded. The tool cannot
be used until it has completely
cooled down again.
GB
9