Inserting/Replacing The Batteries; Installation; Operation - FLORABEST HG00549 Bedienungs- Und Sicherheitshinweise

§ Inserting/replacing the
batteries
Open the battery compartment
¾
Insert 2 AA size batteries (LR06/Mignon) in the
¾
battery compartment
10
are correct according to the polarity markings on the
battery compartment and batteries.
Carefully close the battery compartment.
¾
The display is switched on and the system time
¾ 2
starts at 0:00 hrs.
§ Installation
For the safe and trouble-free operation of the appliance,
the following requirements must be met at the installation
location:
The temperature of the water flowing through the
¾
computer may not exceed 40°C.
Minimum operating temperature +5°C.
¾
Use only clean, fresh water.
¾
Connect the appliance vertically, with the hose
¾
connection at the bottom in order to prevent water
9
entering into the battery compartment
CAUTION! The irrigation computer may only be
connected to a drinking water outlet with a protective
appliance that complies with at least type HD
according to EN 1717 (backflow preventer with pipe
ventilation).
NOTE: Suitable adapters are available from
specialist shops.
Check the type of available water outlet. The
¾
appliance is equipped with a union nut
taps with a 33.3 mm thread (G 1").
The adapter is used to connect the appliance to
12
water taps with 26.5 mm thread (G ³ ⁄
Insert the sieve into the union nut
11
¾
the position shown in the picture on the fold-out page.
For 26.5 mm threads (G ³ ⁄
¾
to the water tap manually. Do not use pliers.
Screw the union nut
¾ 1
8 GB/CY
.
10
. Ensure that the polarities
.
10
for water
1
").
4
according to
1
"): Screw the adapter
12
4
onto the thread of the water
tap or the adapter manually. Do not use pliers.
Screw the hose connector
¾
connection . A hose can then be connected to the
9
hose connector.
Open the water tap.
¾
If leaks/leakages occur when using the adapter
¾
wrap some sealant tape around the thread of the
water tap.
§ Operation
Please refer to the fold-out pages for operation and
programming of the appliance. All required steps are
graphically displayed here.
Switching¾the¾appliance¾on/off:
¾
See Figure 1.
Setting¾time:
¾
See Figures 1–6.
Programming¾irrigation¾1¾and¾2:
¾
See Figures 7–26.
Setting¾the¾irrigation¾interval:
¾
See Figures 27–29.
Starting¾manual¾irrigation:
¾
See Figure 30.
Setting¾start¾time¾for¾manual¾irrigation:
¾
See Figures 31–35.
NOTE: The manually set irrigation time will be saved
and automatically set for the next manual irrigation.
To change the irrigation time follow the instructions as
in Fig. 31–35.
Ending¾manual¾irrigation:
¾
See Figure 36.
Note that for certain functions you must press and
¾
hold the button for a few seconds, according to the
diagrams on the fold-out pages. For other functions
briefly pressing is required.
Activate programming mode by pressing the
¾
. You can either make all the settings one after the
5
other or switch between the following setting options
by pressing the button
onto the hose
13
,
12
button
:
5