Maintenance; Change Grinding Belt - Holzmann MSM 100L Bedienungsanleitung

5 MAINTENANCE

Cleaning and maintenance at connected machine:
Heavy injuries may occur through turning on.
So you always have to turn off the machine and disconnect it from the power supply
The machine requires barely any maintenance. However, if malfunctions and defects occur, let it
be serviced by trained persons only.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Before first operation as well as later on every 100 operation hours you should lubricate al con-
necting part (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers.
Replace them if required.
Check regularly the condition of the guiding rollers of the saw blade. The good condition and per-
fect adjusting of the guiding rollers is essential for a smooth band saw transport and a clean cut.
Store the machine in a closed, dry location.

5.1 Change grinding belt

Turn the machine off
Assure yourself that the belt does not move anymore
Open the side cover
Loosen the belt with the lever shown in the picture
Remove the old belt and install the new belt (Place attention on the arrow shown on back-
side of the belt and install the belt accordingly)
Tighten the belt with the lever
Close the side cover
HOLZMANN Maschinen Austria
Operation manual metal grinding machine MSM 100L
www.holzmann-maschinen.at
A T T E N T I O N
WARTUNG
A
Page 9
metal grinding machine MSM 100L