Waeco MagicWatch WPS900F Montage- Und Bedienungsanleitung Seite 46

Using the parking aid
The front sensors are deactivated when
 the speed of the vehicle is more than 10 km/h
 you press the external button or the right button on the control unit briefly
Press one of the two button for at least 5 s to deactivate the front sensors
until the next time the vehicle is started.
A
NOTICE!
Stop the vehicle immediately and investigate the situation
(getting out if necessary), if the following happens while you are
manoeuvring:
the device first indicates an obstacle and the tone sequence
speeds up normally (e.g. from slow to medium) when manoeu-
vring. The signal tone suddenly slows down, or no obstacle is
indicated at all.
This means that the original obstacle is in the blind spot of the
sensors (construction-related characteristic), and there is still a
potential for collision.
A
NOTICE!
Be especially careful when manoeuvring after the system has
been disconnected from the front or rear sensors.
The system will indicate this fault by:
 the speaker will emit a double alarm tone.
 the red LED in the control unit and the LED on the external
button flash continuously.
I
NOTE
When the stop zone is reached, the volume of the continuous tone
will fall by about 50 % after a short time.
42
WPS900F/WPS910
EN