Waeco MagicWatch WPS900F Montage- Und Bedienungsanleitung Seite 42

Setting the system
➤ Start programming as follows:
– Switch on the ignition.
– Engage reverse gear.
– Press the left button on the control unit for 5 seconds.
The loudspeaker emits a peep tone once, and both LEDs light up.
➤ Set the preferred value (fig. i; chapter "Programming functions" on
page 39).
The right button of the remote control is used to set the tens, and the left
button is used to set the units for the preferred value. For example, if you
wish to set the function "24", press the right button twice and the left but-
ton four times.
➤ Once you have set the desired value, wait until the loudspeaker beeps in
accordance with the value you have set and the respective LED flashes
accordingly.
➤ Switch the ignition off.
Configuring the front sensors
The front parking aid is always activated when you:
 Switch on the ignition
 Engage the reverse gear (WPS910 only)
 Briefly press the right button on the loudspeaker (< 5 seconds)
 Press the external button (< 5 seconds)
38
WPS900F/WPS910
EN