Description; Overview; Packing List; Installation - Cramer 82ZT132 Bedienungsanleitung

EN
1

DESCRIPTION

1.1

OVERVIEW

See separate figure sheet 1-12
ROPS (Roll Over
1
Protective Structure)
Steering control
2
levers
Safety belt
3
Left control panel
4
Right control panel
5
Height adjustment
6
lever
Deck
7
Discharge chute
8
ETO socket
9
10 Charging port
11 Key of battery pack
protection
12 Anti-scalp wheels
13 Front wheel
14 Drive wheel
15 Attachment port
16 Digital display
17 Push button switch
18 High/Low for driving
speed
19 ON/OFF for blade
(PTO)
20 Power ON/OFF for
accessory (ETO)
1.2

PACKING LIST

See figure 0
1. Unassembled machine
(1)
2. Upper handle
assembly (1)
3. ROPS assembly (1)
4. Seat assembly (1)
5. Blade assembly (1)
2

INSTALLATION

2.1 INSTALL THE ROLL OVER
PROTECTION STRUCTURE
(ROPS)
See figure 3
1. Insert the celvis pin into the hole.
2. Insert the R-pin into the hole on the celvis pin.
English
21 High/Low for blade
speed
22 Clevis pin
23 R-pin
24 Thumb screw
25 Neutral bypass knob
26 Upper control lever
28 Lower control lever
29 Seat adjustment lever
30 Cyclone float knob
31 Deck height
adjustment pin
32 Quick charging port
33 Standard charging
port
34 Port cover
35 Mulching blade
36 Mulching cover
37 Side mulcher plate
38 Blade motor
39 Cutting blade
40 Side discharge chute
41 Seat plug
42 Magnetic bar
6. Discharge chute
assembly (1)
7. Charger (1)
8. Owner's manual (2)
9. Figure sheet (1)
2.2 INSTALL THE STEERING
CONTROL LEVER
See figure 4
1. Align the upper control handle with the lower control
handle.
2. Insert the screw together with the washer into the hole.
2.3

INSTALL THE SEAT

See figure 5
1. Place the seat assembly over the mounting brackets and
align holes as shown.
2. Connect the seat plug (41) to the machine.
3. Install the bolts, washers and nuts and tighten securely.
4. Make sure it is securely seated.
3

KNOW YOUR MACHINE

3.1 ELECTRIC TAKE OFF (ETO)
SOCKET FOR CONNECTING
ACCESSORIES
See figure 1 (Point 9)
The machine can be used together with other attachments
such as the blower.
3.2

CONTROL PANEL

3.2.1 LEFT CONTROL PANEL
See figure 2
# Name Function
16 Digital dis- This display shows important electrical
play system information. Refer to the Electri-
cal section for complete information.
17 Push button On/off. With magnetic bar inserted, press
switch (See the push button switch to activate the
figure sheet machine; press the push button switch
picture 2) again to stop the machine
3.2.2 RIGHT CONTROL PANEL
See figure 2
4