Addressing; Dmx-Protocol - EuroLite LED TMH-19 Moving-Head Beam Bedienungsanleitung

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-19 will respond to the controller.
If you set the address to channel 14, the device will use the channel 14 to 26 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-19 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-19 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-19 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.

DMX-protocol

CH Decimal Hexad. Percentage S/F
1
0 255 00 FF
2
0 255 00 FF
3
0 255 00 FF
4
0 255 00 FF
5
0 225 00 E1
226 255 E2 FF 89% 100%
6
0 255 00 FF
7
0 255 00 FF
8
0 255 00 FF
9
0 255 00 FF
10
0 9 00 09
Horizontal movement (PAN)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-
0% 100% F
255, 128-center). The head can be stopped at any position you
wish.
PAN-movement with 16-bit resolution
0% 100% F Fine indexing
Vertical movement (TILT)
Push slider up in order to move the head vertically (TILT). Gradual
0% 100% F
head adjustment from one end of the slider to the other (0-255, 128-
center). The head can be stopped at any position you wish.
TILT-movement with 16-bit resolution
0% 100% F Fine indexing
PAN/TILT speed
0% 88% F
Decreasing speed
S
No function
Red
0% 100% S
Red (0=off, 255=100% red)
Green
0% 100% S
Green (0=off, 255=100% green)
Blue
0% 100% S
Blue (0=off, 255=100% blue)
White
0% 100% S
White (0=off, 255=100% white)
Switching the LEDs, Strobe
0% 4%
S Neutral
Feature
26/31 00091769, Version 1.0