Kärcher KM 150/500 R D Bedienungsanleitung Seite 26

Manually clean the dust filter
 Clean the dust filter with the filter clean-
ing button.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.
2
1
 Open filter cap.
 Fold the filter vibrator forward.
 Replace the dust filter.
 Close the filter cover.
26
Check and adjust the V-Belt
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.
 Get the V-belt tension adjusted by an
authorized customer service.
Check air filter and replace, if necessary
 Remove the air filter housing.
 Replace the air filter insert.
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
Changing the headlight bulb (option)
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.
 Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Changing the blinker bulb (option)
Note: Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.
10
-
EN
Replacing fuses
 Open the fuse holder.
 Check the fuses.
Note: The fuses FU 01 and FU 14 are lo-
cated in the motor compartment.
FU 01 Main fuse
FU 02 Warning system
FU 03 Safety relay
Multifunction display
FU 04 Fuel pump
FU 05 Time relay
Seat contact switch
FU 06 Horn and ventilator mo-
tor hydraulic cooler
FU 07 Program selection
switch
Waste container func-
tions
FU 08 Brake light switch
Direction-indicator
lamp
FU 09 Left lighting
FU 10 Right lighting
FU 11 Front work lights (low
beam)
FU 12 Vibrator system
Beacon lamp
FU 13 Water pump
Capacitor ventilator
Cabin lighting
Wiper
3. Side brushes
Blower motor cabin
FU 14 Fanmotor capacitor
* Fuse protection up to 30 A, depending on
the installed upgrade kit (the correct fuse
is already inserted in the factory)
 Replace defective fuses.
Note: Only use fuses with identical safety
ratings.
60 A
10 A
10 A
10 A
30 A
25 A
10 A
10 A
7,5 A
7,5 A
10 A
20 A
10 A *
40 A