AERMEC FCW 212V Bedienungsanleitung Seite 35

TLw2 - INfRA-RED REMOTE CONTROL
IMpORTANT
Note for fCw series with microprocessor controller:
- The two control types, wired control panel (pfw2) and remote control (TLw2), cannot be used at the same time on the
same fan coil unit.
– If the fan coil is off, all the previous settings made are kept in the memory except for the TIMER setting and SLEEp mode.
– If the fan coil is turned on using the (ON/Off) key, the TIMER setting and SLEEp mode are cancelled.
1
3
2
12
5
15
14
9
1 - ON/Off
Turning on and off.
2 - MODE
Press this button to set the various operating modes: automatic (AUTO),
cooling (COOL), dehumidification (DRY), heating (HEAT) and ventilation
(FAN).
3 - TEMp and
Temperature control buttons (16 to 30 °C).
17
Use these buttons to set the temperature you wish to have in the room,
TEMp to increase the temperature and TEMp
When the two TEMp
time the unit of temperature measurement changes between °C and °F.
4 - fAN
Press this button to select the fan speed: automatic (AUTO), low (LOW),
16
medium (MED) and high (HIGH).
5 - SLEEp
Button to enable the night comfort function (SLEEP).
6 - SwING
Press this button to enable to swinging of the horizontal blades.
7 - LOUvER
Press this button to regulate the vertical air flow, with 4 fixed positions
4
plus swinging blades.
8 - SEND -
Press this button to transmit the parameters shown on the display to the
8
unit.
7
9 - LIGHT
13
Hold the LIGHT button for 3 sec switches the display light on or off.
6
10 - LOCk
10 Hold the LOCK button for 3 sec to lock or unlock all the other buttons.
11 - SET
11
Press this button to save the clock or the timer on/off settings.
12 - TIMER ON
Press this button to set the timer on function.
13 - TIMER Off
Press this button to set the timer off function.
14 - CLOCk
Press this button to set the clock function.
15 - DISpLAy
Press this button to turn the remote control display on or off.
16 - LCD DISpLAy
Shows the settings of the fan coil unit.
17 - TRANSMITTER
Sends the signals to the fan coil unit receiver.
It must be pointed at the receiver.
TEMp - TEMpERATURE (°C)
and TEMp buttons are pressed at the same
IFCW3LJ 1210 - 5375700_01
to decrease it.
35