AERMEC FCW 212V Bedienungsanleitung Seite 34

fCw wITH MICROpROCESSOR CONTROLLER - fRONT pANEL DISpLAy
When the fan coil unit is powered up it emits a beep.
1 - TEMpERATURE DISpLAy / ERROR CODES
- In normal operation shows the room temperature
- If the set point temperature is changed the new value in °C
will blink for 5 seconds
- Room sensor error: E1 will blink
- Internal sensor error: E2 will blink
- Water sensor error: E3 will blink
- Water temperature sensor error: E4 will blink.
2 - fAN SpEED
3 - OpERATING MODE
Dehumidification
Cooling
Heating
Fan only
4 - TIMER
The icon shows the timer is active
fCw wITH MICROpROCESSOR CONTROLLER - AUXILIARy EMERGENCy SwITCH
AUXILIARy EMERGENCy SwITCH
When the remote control is not available (not functioning or
with flat batteries) or the wired control panel is not func-
tioning, the auxiliary emergency switch can be used to
activate the fan coil unit.
The switch is not sized for continuous use. Repair the
remote control or the wired control panel as soon as pos-
sible.
Starting and operating with the auxiliary emergency switch
(AUX):
- First press: Cooling with set point 25°C, automatic venti-
lation, swinging blades
- Second press: Heating with set point 22°C, automatic
ventilation, swinging blades
- Third press: Fan coil unit turned off
34
IFCW3LJ 1210 - 5375700_01
When the fan coil unit is powered but not on, all the LEDs
are off.
AUX
( On / Off )