Before Installation Of The Uv Streamer Air Purifier Unit - Daikin BAEF125AWB Installationsanleitung

5. BEFORE INSTALLATION OF THE UV STREAMER AIR PURIFIER UNIT

1. Wipe clean the bell-mouth of the indoor unit using a dry cloth or similar. (Refer to Figure 2.)
2. Attach sealing material (8) along the end of the bell-mouth radius (12 mm from the its tip) for the entire
perimeter, making sure not to overlap the sealing material ends.
In doing so, ensure the slits in sealing material (8) are on the inner side.
* If the sealing material ends overlap after being attached around the entire perimeter, remove the
overlapped portion by cutting.
3. Wipe clean the flat part of the lifting lug next to the refrigerant pipe with a dry cloth or similar.
4. Attach wire clamp (7) to the flat part of the lifting lug of the indoor unit. (Refer to Figure 3.)
Sealing material (8)
(Accessory)
7
01_EN_3P701968-3.indd 7 01_EN_3P701968-3.indd 7
End of radius
(Line on the inside of the bell-mouth)
Ventilation path
Bell-mouth
Sealing material (8)
(10 mm)
(Accessory)
Cross-section A-A
Slit
A
A
Bell-mouth
Figure 3
Sealing material (8)
(Accessory)
Figure 2
Lifting lug
Flat part
Wire clamp (7)
(Accessory)
English
12/05/2023 15:12:25 12/05/2023 15:12:25