Electrical Wiring Work - Daikin BAEF125AWB Installationsanleitung

7. ELECTRICAL WIRING WORK

WARNING
Be sure to cut off all power supplies for the air conditioner (both indoor and outdoor units) before carrying
out wiring work.
Failure to do so may result in electric shock.
• Connect the wiring of the UV streamer air purifier unit to the indoor unit control box. (Refer to Figure 14.)
* After securing the wiring, cut away the excess portions of the clamps.
* Use relay harness (3) for standard panel.
• Pull out the power supply wires (black and white) and the earth wire (green or yellow) pushed into the UV
streamer air purifier unit in step "5. INSTALLATION OF UV STREAMER AIR PURIFIER UNIT", and
connect to the indoor unit power supply terminal block.
• Pass the signal wire (grey) through wiring through-hole 2, and connect to connector X6A (grey) on the
printed circuit board of the indoor unit.
In doing so, pass the signal wire under hooks 1 and 2.
• Pass relay harnesses (3) through wiring through-hole 2 to connect the male side of relay harness (3) to
connector X36A (white). In doing so, pass relay harness (3) under hook 1.
11
01_EN_3P701968-3.indd 11 01_EN_3P701968-3.indd 11
Tape
Figure 11
Indoor unit
UV streamer
air purifier unit
Installation completion diagram
English
12/05/2023 15:12:29 12/05/2023 15:12:29