Specifications; Standard Accessories; Prior To Operation - Hitachi Koki VB 16Y Bedienungsanleitung

English
6. If you accidentally drop the unit or knock it against
something, thoroughly examine the unit and ensure
that there are no damages, cracks, or deformations
on the cutter and unit.
7. If you use the machine continuously, the inner
cover and gear cover can become hot. After such
continuous use, do not touch the inner cover and
gear cover. (Fig. 1)

SPECIFICATIONS

Voltage
Power Input
Capacities
Number of piece(s) that
can be processed at one time
Weight

STANDARD ACCESSORIES

(1) Allen key (For M5 hexagon socket bolt)
.................................................... 1 (attached to unit)
(2) One set of cutters ................... 1 (attached to unit)
OPTIONAL ACCESSORIES (sold separately)
1. Cutter
* One set containing two pieces
2. Center Roller (D 50) Set
50 mm
(R25 mm)
* This is used when the bending diameter of a rebar
is changed to (bent diameter: R 25).
3. Center Roller (D 38) Set
38 mm
(R19 mm)
7
8. Do not immerse unit in water as this may cause
malfunction or electric shock.
CAUTION:
Install the cutter and accessories securely according
to the handling instructions. If you fail to install
them properly, they may come off and cause an
injury.
Be sure to unplug the power cord from the receptacle
when the cutter is checked, cleaned, and replaced.
Failure to do so can result in a serious injury.
(1) Material: Rebar, equivalent grades: GRADE 460 (Great Britain),
BST 500 (Germany), B500 (Spain) and FeE 500 (France)
(2) Diameter of material: 8 – 16 mm
Cutting
ø10 mm 2 pieces
ø12 mm 1 piece
ø16 mm 1 piece
* This is used when the bending diameter of a rebar
is changed to (bent diameter: R 19).
4. Case
* Outer dimensions
525 × 346 × 236 (mm)
APPLICATIONS
Cutting of rebar
Bending of rebar

PRIOR TO OPERATION

WARNING!
Before use, check the following items. Concerning items
1-7, always be sure to check them before plugging the
power cord into the receptacle.
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
Also, avoid using DC power or engine generators.
Not only will the tool get damaged but an accident
can result.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
(110 V, 230 V)
510 W
ø10 mm 3 pieces
ø12 mm 2 pieces
ø16 mm 1 piece
17.0 kg (excluding cord)
Bending