Hitachi Koki VB 16Y Bedienungsanleitung Seite 9

3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
4. Preparation and
environment.
Check and confirm if the workplace is in proper
conditions as mentioned in the general operational
precautions item 1.
5. For safety sake, use the provided Allen key to make
absolutely sure that the hexagon socket bolt is
securely clamped. Use of the unit with the bolt in
PICTGRAPH ILLUSTRATION AND
EXPLANATION
Read handling
instructions before use.
Begin operation only after
ensuring that there are no
people within the turning
range of the material to be
bent.
(Returning Halfway)
1 Select RETURN with the dial.
1 Pull the triger.
confirmation of working
Do not this electric
power tools in wet
wether conditions.
Never bring your
hand close to the
cutter during
operation.
a loosely clamped condition can result in damage
to the unit and cutter as well as accidents.
6. Confirm that the cutter is in sharp condition.
Make certain that the cutter is in a sharp condition.
Continued use of a worn out and deformed cutter
with dull edges results in damage to the unit and
cutter as well as accidents.
7. Check plug receptacle.
If a receptacle jounces or a plug comes out easily
when a power cord is plugged in, the receptacle
needs to be repaired. Consult the nearest electric
service station for repair. Continued use of the
defective receptacle can result in overheating and
accidents.
If the switch is turned off and then
immediately turned on again, the motor
may not start. Wait for at least one full
second before attempting to turn the motor
on again after it has been switched off.
Avoid any work exceeding
the maximum capacities.
(Rebar diameter ø16 mm.)
(Selecting the rebar size)
Select the rebar size and the
bending angle.
ø12
ø10
ø16
English
8