Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and Connections
Connecting this unit to the monitor
This unit is to be used only when connected to the
plasma display, PDP-502MXE. Follow the procedure on
this page to connect this unit to the plasma display.
Before connecting this unit to the display, please be
sure to do the following:
÷ Undo any component or personal computer
connections that may have already been made to the
plasma display.
÷ Make sure that the power of the plasma display is
turned off, and is unplugged from the wall outlet.
Precautions when connecting this unit to the display
When the covers on this unit and/or the display are
opened to make connections, be sure to avoid letting the
screw rivets or their respective parts fall into openings on
the units.
CAUTION
This unit is designed only for connection to the plasma display,
PDP-502MXE. Do not alter or modify this unit in any way as it
may cause this unit to perform abnormally and/or may cause the
plasma display to malfunction.
To connect this unit to the plasma
display PDP-502MXE
1 Remove the cover plate on the back panel of the
plasma display.
Note
If for some reason the screws cannot be unscrewed, use a tool
or other object with a tip flat enough to fit between the screw
and rivet and pry the screw out as shown below.
Unscrew using a
philips screwdriver
("+" head).
2 Remove the cover plate on the back panel of the
plasma display.
The two cable connectors are attached to the inside of
the cover plate.
3 Separate the two connector cables from the cover.
4 Pull the two connector cables through the slot on
the connector cover included with this unit.
5
<ARE1351> En
Werbung
