Pioneer PDA-5001 Bedienungsanleitung Seite 20

Setting Up the System
G ON SYNC setup (CLAMP)
The RGB video signal is normally composed of 5 signals:
R, G, B, HD and VD. With G ON SYNC connection,
however, the signal is composed of 3 signals: R, G (G, HD
and VD combined) and B.
If the component being used is a model where G ON
SYNC connection is carried out, on-screen setup is
necessary.
Setup of G ON SYNC (CLAMP) connection
1
Press MENU to display the menu screen.
The menu screen appears.
2
Press 5/∞ to select SET UP, and press SET.
M A I N M E N U
P I C T U R E
S C R E E N
A L L R E S E T
P OW E R S A V E
S E T U P
M E N U : M E N U
O F F
: S E L E C T
3
Press 5/∞ to select CLAMP.
S E T U P
T E R M I N A L : B N C
S E T T I N G : P C
S I G N A L : R
C L A M P : M O D E 1
A B L : O F
:
H . E N H A N C E
:
V . E N H A N C E
E X I T
: S E L E C T
4
Press SET to select MODE2.
Mode selection will change as follows each time SET
is pressed.
3 MODE1
(Normal connection)
MODE2
(G ON SYNC connection)
5
When the setup is completed, press MENU to exit
the menu screen.
16
<ARE1351> En
S E T : N E
X T
G B
F
0
0
S E T : C H
A N G E
2
Notes
÷ Make this G ON SYNC setting for each applicable input
(INPUT3 and INPUT4).
÷ When using this setup, be sure to carefully check the signal
output of the component that you are using. For details, please
refer to the instruction manual supplied with the component
you are connecting.
÷ If the screen becomes bright and turns a greenish color, set
CLAMP to MODE2.
÷ G ON SYNC connection is carried out on some Macintosh
computers.