Pioneer PDA-5001 Bedienungsanleitung Seite 28

Display Panel Adjustments
Resetting the monitor to factory set
defaults
1
Press MENU to display the menu screen.
The menu screen appears.
2
Press 5/∞ to select ALL RESET, then press SET.
M E N U
M A I N
P I C T U R E
S C R E E N
A L L R E S E T
P OW E R S A V E
S E T U P
M E N U : M E N U
O F F
: S E L E C T
3
Press 2 to select YES, then press SET.
All settings of the PICTURE and SCREEN modes are
returned to the default settings (factory set defaults).
A L L R E S E T
A D J U S T
Y E S
: S E L E C T
24
<ARE1351> En
S E T : N E
X T
A L L R E S E T ?
N O
S E T : E X I T
Additional Information
Troubleshooting
This unit is to be used only when connected to the
plasma display, PDP-502MXE. Should you experience
what seems to be an malfunction, turn the plasma
display's power off and check the following.
÷ Are connections between this unit and connected
components made correctly ? (Pages 7 to 12)
÷ Are the connector cable connections between this unit
and the plasma display monitor made correctly? (Page 5)
Additionally, check the following sections in the
instructions included with the PDP-502MXE.
÷ Common Problems
÷ Problems commonly mistaken as breakdown
÷ About the self diagnosis mode
If, after checking all the points listed above, the problem
can still not be solved please consult the dealer where
this unit was purchased.