Werbung
TROUBLESHOOTING
SYMPTOM
REMEDY
POOR SOUND QUALITY
The sound is unstable or
interrupted.
*
The heads, pinch rollers and capstans are dirty.
*
The tape is not uniformly wound.
*
Clean the heads, etc. (see page 8).
*
Fast forward or rewind the tape completely.
There are no high
frequencies.
*
A tape recorded without Dolby NR is being
e
Set the DOLBY
NR switch to OFF.
played back with the DOLBY
NR switch set to
B or C position.
*
The heads are dirty.
*
Clean the heads (see page 8).
High frequencies are em-
phasized.
*
A Dolby NR tape is being played back with the
*
Set the DOLBY
NR switches to the same posi-
DOLBY
NR switch set to OFF.
tions used for recording.
The sound from previous
recordings remains when
the tape is re-recorded.
The heads are dirty.
*
Clean the heads (see page 8).
The sound is distorted.
The recording level is too high.
*
Turn the REC LEVEL control down (see page
26).
*
The recorded signal itself is distorted.
*
Replace the cassette tape.
The heads are dirty.
*
Clean the heads (see page 8).
There is too much noise.
A noisy tape is being used.
There is a faulty connection.
The recording level is too low.
The heads are dirty.
The head is magnetized.
*
Replace the cassette tape.
*
Check all connections (see page 10).
*
Turn the REC LEVEL control up (see page 26).
*
Clean the heads (see page 8).
e
Demagnetize the head with a demagnetizer
(see page 8).
The music search func-
*
The blanks between selections are less than 4
*
Use a tape with blanks between selections of
tion does not operate
seconds long.
at least 4 seconds.
properly.
Recording or playback
The TIMER switch is set to PLAY or REC.
*
Set the TIMER switch to OFF.
starts suddenly when
the power is turned on.
CDeDECK
SYNCHRO
*
The CDeDECK
SYNCHRO
control cord and In-
e
Connect correctly (see page 10).
recording cannot be
put/Output cords are not connected.
carried out.
*
The cassette tape accidental erasure prevention
| *
Replace the cassette with one whose tabs are
tabs are removed.
intact (see page 6).
The CD SYNC indicator
*
The tape ran out during the CDeDECK
SYN-
*
Replace the tape with a longer one.
is off during CDeDECK
CHRO
mode.
SYNCHRO
recording.
*
After the deck entered recording standby
*
Change the disc and press the CD SYNCHRO
mode, more than 1 minute elapsed before the
button again.
CD player resumed playback.
39
<RRE1056 >
En
Werbung
