Werbung
Verfügbare Sprachen
Verfügbare Sprachen
F
4. Press the double-sided adhesive tape on the four sides on the bottom of the
appliance (H) to fix the bottom cover to the bottom of the appliance firmly; see
below, fig. 4.
F
G
H
2.6 Connection of the water inlet hose
➢ Do not use a water connection the water of which is warmer than 50 °C.
➢ Required water pressure (flow pressure): 100 kPa - 1000 kPa (1 - 10 bar).
➢ The appliance must not be connected to the mixer tap of an unpressurised water
heater.
➢ Check the connections for leaks by turning the tap on completely.
➢ If the water inlet hose is too short, replace it with a suitable length of a pressure-
resistant water inlet hose (1000 kPa/min).
➢ Check the water inlet hose regularly for brittleness and cracks and replace it if
necessary.
C
OVER
C
OVER
B
OTTOM OF THE APPLIANCE
➢ press the adhesive tape of the bottom cover firmly in place.
of the drain pump filter
of the drain pump filter
A
DJUSTABLE FOOT
~
~
98
:
Werbung
