Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTICE! Never open the door as described above when the appliance
operates normally.
NOTICE! Any damage to the appliance and / or the door caused by
forcible opening of the door are not subject to the guarantee or the
warranty!
4.6 End of a washing programme
❖ When a programme has ended, the display indicates the word « END » and an
acoustic signal sounds (if the acoustic signals are activated / see also chapter 4.4.1
S
ELECTION OF THE ADDITIONAL FUNCTIONS
❖ After 2 minutes without using any operating buttons, the programme is switched
off automatically.
❖ The door lock is deactivated automatically.
1. When the programme is finished, the display indicates the word « END » and an
acoustic signal sounds.
2. The door lock is deactivated automatically. The operational status indicator of the
door lock goes off: «
3. When the programme is finished, always turn the
programme selection back to « O
4. Close the water tap.
5. Open the door and remove the laundry.
6. Leave the door and the detergent dispenser slightly opened, so the moisture can
escape completely.
4.7 Selection of a new washing programme / function
❖ You must switch off the appliance first to cancel the old settings and to be able
to make new settings.
1. During a washing cycle, turn the rotary knob for the programme selection to
position « O
FF
to switch off the appliance and cancel all settings.
2. Set a new programme and new functions if desired.
3. If needed, set a new spin speed.
4. P
LEASE NOTE
5. Press the « S
TART
Depending on model.
41
41
».
». Leave the rotary knob in this position for at least 3 seconds
: do not add more detergent!
/ P
» -
AUSE
BUTTON
).
» to switch off the appliance completely.
FF
to start the new programme.
~
~
134
for the
ROTARY KNOB
Werbung
