Technical Data - Scheppach MBS1200xt Original Bedienungsanleitung

Additional safety instructions - portable band
saws
• When performing work during which the cutting de-
vice could come into contact with concealed power
lines, hold the electrical tool by the insulated handle
surfaces. Contact between the cutting tool and a
live power line can also electrify metal device parts
and lead to an electric shock.
• Keep your hands away from the sawing area and
saw band.
• Before use, always ensure that the portable band
saw is clean.
• Stop operation immediately, if you notice anything
unusual.
• Prior to using the tool, always make sure that all
components are properly and safely fitted.
• Always proceed with caution when fitting or remov-
ing the saw band.
• Always keep your hands away from the cutting path
of the saw band.
• Before sawing, always wait until the motor has
reached full speed.
• Always keep the handles dry, clean and free of oil
and grease. Hold the tool firmly during work.
• Always remain alert, in particular when performing
repetitive, monotonous tasks. Always make sure
your hands are in the correct position in relation
to the saw band.
• Never remove the workpiece stop.
• Maintain a distance from end pieces, which fall
down after sawing. They may be hot, sharp and/or
heavy. They could cause serious injuries.
• Air intakes often cover moving parts and should be
kept clear. Loose-fitting clothing, jewellery and long
hair may become caught in the moving parts.
Residual risks
The electric tool is state-of-the-art and has been built
according to the recognised technical safety regula-
tions. However, individual residual risks can arise dur-
ing operation.
• Danger of injury for fingers and hands due to the
running saw band with improper guiding of the work-
piece. Injuries due to the workpiece being ejected
at high speed due to improper holding or guiding,
such as working without the stop.
• Risk to health from wood dust or wood chippings.
It is essential that personal protective equipment,
such as eye protection, is worn.
• Injuries due to defective saw band. Check the integ-
rity of the saw band regularly.
• Danger of injury for fingers and hands when chang-
ing the saw band. Wear suitable work gloves.
• Danger of injury when the machine is switched on
from the running saw band.
• Hazard due to electrical power, with the use of im-
proper electrical connection cables.
• Danger to health from running saw band due to long
hair and loose clothing. Wear personal protective
equipment such as a hair net and close-fitting work
clothing.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "General
safety instructions" and the "Proper use" are ob-
served along with the whole of the operating in-
structions.

6. Technical data

AC motor
Engine output
Cutting width at 90°
Cutting width at 45°
Idle speed
Saw band
Saw band speed
Protection class
Pivot range
Technical changes reserved!
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB (A), please
wear suitable hearing protection.
The noise and vibration levels have been determined in
accordance with EN 60745.
Noise data
Sound power level L
Sound pressure level L
Uncertainty K
www.scheppach.com
127 mm x 127 mm
127 mm x 40 mm
1140 x 12.7 x 0.65
101.7 dB(A)
WA
90.7 dB(A)
pA
3 dB(A)
wa/pA
230 V~ / 50Hz
1100 W
0-290 rpm
0-2.4 m/s
II
0-45°
GB | 25