Before You Begin - Matrix ENDURANCE UPRIGHT Bedienungsanleitung

BEFORE YOU BEGIN

LOCATION OF THE UNIT
Place the equipment on a level and stable surface away from direct sunlight. The
intense UV light can cause discoloration on the plastics. Locate your equipment in
an area with cool temperatures and low humidity. Please leave a clear zone on both
sides of the equipment that is at least 24" (600 mm). This zone must be clear of any
obstruction and provide the user a clear exit path from the machine. Do not place
the equipment in any area that will block any vent or air openings. The equipment
should not be located in a garage, covered patio, near water or outdoors.
LEVELING THE EQUIPMENT
The equipment should be level for optimum use. Once you have placed the equipment
where you intend to use it, raise or lower one or both of the adjustable levelers located
on the bottom of the frame. Use 6mm hex key through the access hole (shown below).
A carpenter's level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
POWER
If the equipment is powered by a power supply, the power must be plugged
into the power jack, which is located in the front of the equipment near the
stabilizer tube. Some equipment has a power switch, located next to the power
jack. Make sure it is in the ON position. Unplug cord when not in use.
WARNING!
Never operate equipment if it has a damaged cord or plug, if it is
not working properly, if it has been damaged, or immersed in water.
Contact Customer Tech Support for examination and repair.
ENGLISH
FREE AREA
0.6 0.6
m m
(2 ) (2 )
ft ft
TRAINING AREA
11
0.6
m
(2 )
ft