Before You Begin - Matrix ENDURANCE Bedienungsanleitung

BEFORE YOU BEGIN

LOCATION OF THE UNIT
Place the equipment on a level and stable surface away from direct sunlight. The intense UV light
can cause discoloration on the plastics. Locate your equipment in an area with cool temperatures
and low humidity. Please leave a clear zone on both sides of the equipment that is at least 24"
(600 mm). This zone must be clear of any obstruction and provide the user a clear exit path from
the machine. Do not place the equipment in any area that will block any vent or air openings.
The equipment should not be located in a garage, covered patio, near water or outdoors.
LEVELING THE EQUIPMENT
The equipment should be level for optimum use. Once you have placed the equipment
where you intend to use it, raise or lower one or both of the adjustable levelers located on
the bottom of the frame. Use 6mm hex key through the access hole (shown below).
A carpenter's level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
POWER
If the equipment is powered by a power supply, the power must be plugged into the power jack, which
is located in the front of the equipment near the stabilizer tube. Some equipment has a power switch,
located next to the power jack. Make sure it is in the ON position. Unplug cord when not in use.
WARNING!
Never operate equipment if it has a damaged cord or plug, if it is not working properly, if it has been
damaged, or immersed in water. Contact Customer Tech Support for examination and repair.
FREE AREA
0.6 0.6
m m
(2 ) (2 )
ft ft
TRAINING AREA
0.6
m
(2 )
ft
11