Connection To The Electric Network - Saeco NEXTAGE CAP010 Bedienung Und Wartung

English
5.4 Connection to the Electric
Network
The
Technician,
charge of the appliance's
installation, shall make sure
that:
• the power supply system complies with the safety
instructions in force;
• the voltage corresponds to that indicated on the appliance
data plate.
In case of doubt, do not
proceed
installation and ask qualified
and authorised personnel
to accurately check the
system.
Also make sure that the
electrical
appliance is connected to
has the capacity to bear
the max load required, as
indicated on the data plate.
78
Maintenance
who is in
with the
system the
G Power cord type H07RNF sec. 3x2.5 mm2
Insert the power cord (G) into the hole A.
G Power cord type H07RNF sec. 3x2.5 mm2
N Neutral
L1 Phase
T Ground
Depending
regulations in force in the
Country where the machine
is being used, the cable
connecting to the power
supply has to be pre-set or
equipped with an all-pole
switch (with a minimum
contact opening of 3 mm),
or with a plug complying
with the same regulations.
on the