Saeco NEXTAGE CAP010 Bedienung Und Wartung Seite 108

English
The operations describing how to disassemble the
dispenser unit are listed here below:
• Remove the dispenser cover D5 by pulling it towards you.
• Disconnect the coupling D3 from the Cappuccinatore unit
D10 (only for versions with Cappuccinatore).
• Use both your hands to remove the dispenser unit D1 by
pulling it towards you.
• Slide the Cappuccinatore unit D10 upwards (only for
versions with Cappuccinatore).
• Remove the Cappuccinatore
Cappuccinatore unit D10 by turning it upwards (only for
versions with Cappuccinatore).
• Slide the crema adjusting lever D7 upwards (only for
versions with Cappuccinatore).
• Slide the temperature adjusting lever D4 on the left (only
for versions with Cappuccinatore).
• Slide the Cappuccinatore body cover D8 upwards (only
for versions with Cappuccinatore).
• Slide the dispensing spout body cover D12 upwards.
Wash all the components with lukewarm water.
Assemble the components in reverse order.
10.2.10 Cleaning the Drip Tray and
Relative Grill
Remove the grill.
Insert the cap in the drain hole of the drip tray.
Remove the drip tray.
Empty the drip tray.
Clean the drip tray's inside.
Remove the cap from the drain hole of the drip tray.
Reinsert the drip tray.
Refit the grill.
108
10.2.11 Cleaning the Coffee Grounds
fork D6 from the
Drawer
Open the door.
Remove the coffee grounds drawer.
Empty out the coffee grounds.
Wash the coffee grounds drawer under running water.
Refit the coffee grounds drawer in its seat and close the
door.
Make sure that the cap has
been removed from the
drain hole of the drip tray.
Each time
grounds drawer is removed
the coffee grounds counter
is reset to zero.
To reset the
counter, the
grounds drawer must be
removed for longer than 3
seconds.
the coffee
grounds
coffee