Installment; Packaging; Installment Requirements; Electrical Hook-Up - Saeco SIN 007 Bedienungsanleitung

START-UP
4

INSTALLMENT

For personal safety follow the "Safety
regulations" found on pages 20-21.

4.1 Packaging

The original packaging has been designed
to protect the appliance during
transportation.
You are recommended to keep it for later
use.

4.2 Installment requirements

Before installing the machine read the
following safety instructions carefully:
• Locate the machine in a safe place;
• Make sure that it is out of the reach of
children;
• Do not place the machine on a hot
surface or near a naked flame.
The coffee maker is now ready to be
connected.

4.3 Electrical hook-up

Electricity can be dangerous, so
always follow
regulations carefully.
The coffee maker must be connected to a
suitable wall socket.
The voltage must correspond to that
indicated on the rating plate of the
appliance.
Never use a faulty cable.
Faulty plugs and cables must be
changed immediately by authorised
personnel.
The voltage of the appliance has been
factory-set.
The voltage on the rating plate (positioned
on the bottom of the appliance) must
correspond to that of your house electricity
supply.
4.4 Connecting the appliance to
• Uncoil a length of cable from the cable
• Check that the main switch is in the "0"
• Plug the appliance into a wall socket
• Turn on the main switch (3), the light on

4.5 Filling the water tank

•
• Take out the water tank (1) by lifting it.
•
•
the safety
• When the tank is in place, press lightly
• Put the lid back on the tank.
other liquids may damage the tank.
Do not use the coffee maker without
water, always check that there is
enough water in the tank.

4.6 Priming

time, after the appliance has been left
unused for a long period or when the water
and steam have run out, it is necessary to
prime the machine.
the power supply
wind found underneath the appliance,
sufficient for the plug to reach the wall
socket.
position before inserting the plug in the
wall socket.
carrying the correct voltage.
the inside will be on.
Remove the water tank lid (2).
The valve on the bottom of the tank will
not allow water to flow out.
Rinse and fill the tank with fresh water
without overfilling.
Put the tank back in its correct
position.
down on it to insert the valve correctly.
The valve will open automatically.
Always fill the tank with fresh, not
carbonised water: hot water or
Before using the machine for the first
23