Transport; Storage; Maintenance; Disposal And Recycling - Scheppach FS3600 Original Bedienungsanleitung

• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible.
• Rub the product clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts and the surface of the product.

12. Transport

Before transport, the coolant must be drained com-
pletely. Do not use the machine's safety devices for
lifting. Fold in the feet and secure the machine head
with the transport retainers.

13. Storage

Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the power tool.

14. Maintenance

Attention!
Disconnect the mains plug before carrying out any
maintenance work.
The device has no further internal parts that require
maintenance. The ball-bearing machine head guide
must be regularly cleaned of dirt. The pan (4) and cool-
ing water pump (13) must also be cleaned regularly,
otherwise the cooling of the diamond cutting wheel (2)
is not guaranteed.
Rinse the basin (4) and the water pump (13) with clean
water after use.
Maintenance work that is not expressly described in
this operating manual must be carried out by qualified
personnel, as hazardous situations may arise for which
the operator is not prepared.
Replacement of spare parts may only be carried out by
qualified personnel.
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate
Important note in the case of repairs:
When returning the device for repair, please ensure for
safety reasons that it is free of oil and fuel when it is
sent to the service centre.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Cutting wheel, carbon brush, table and
cutting head guides
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

15. Disposal and recycling

Information on packaging
Information on the German Electrical and Elec-
tronic Equipment Act (ElectroG)
Electrical and electronic appliances do not
belong in household waste, but should be
collected and disposed of separately.
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed before disposal. Their disposal is regulated
by the battery law.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 29