Care And Maintenance - Proklima 30280289 Bedienungsanleitung

• Set deactivation time:
– If the air conditioning device is
switched on, press the [Timer] key
and select the required deactivation
time using the temperature and time
setting keys.
– The preset shut-off time is shown on
the control panel.
– The deactivation time can be set in 0-
24 hours at any time.
– To confirm, press the [Timer ] key
again; the timer display shines.
– To deactivate the timer function,
press the [Timer] key until the timer
display goes off.
Automatic swivelling
– After switching the device on, the air
flap continuously swivel up and down;
pressing this key again will stop the
movement and the air flaps remain in
this position.
Sleep mode
– In cooling mode, press the [SLEEP]
key to set the temperature. It will
increase by 1 °C after one hour and by
maximum 2 °C after 2 hours.
– In heating mode, press the [SLEEP]
key to set the temperature. It will
decrease by 1 °C after one hour and by
maximum 2 °C after 2 hours.
– You can stop the setting process by
pressing the [SLEEP] key again.
Wifi function
– Press the [SLEEP] key for 5 seconds to
enter the Wifi setting mode.
– The device is only connected to the
Wifi, if the [WIFI] display shines. If
the [WIFI] display flashes slowly, the
device is in Wifi configuration mode; if it
flashes quickly, the device is connected
to the Wifi;
– You can use all functions of the air con-
ditioning unit via the mobile phone app
and an existing Wifi connection.
Download and install the app
► p. 7, fig. 4
30280289, 30288991
– Use your smartphone to scan the QR
code, or search in the App store to
download and install the app.
► p. 7, fig. 5
– Register and log into the app according
to app's requirements.
Add device – Normal mode
► p. 8, fig. 6
Add device – AP mode
► p. 8, fig. 7
– When in AP mode, check that the dis-
play lamp of the device is flashing
slowly (once every 3 seconds), and
then touch it to go to the next step
– If the display lamp flashes slowly,
touch [how to set light as slow
flashes] to show the operating pro-
cesses.
Add device – Enter Wifi password
► p. 8, fig. 8
Add device – Adding failure
► p. 9, fig. 9
– If the app interface, as shown on the
screen, appears, this means that the
network connection has failed. Try
again by reconnecting or call up the
help menu.
Control device
► p. 9, fig. 10

Care and maintenance

DANGER! Risk to life! Always
disconnect the device from the
mains supply before carrying out
any cleaning or maintenance work.
DANGER! Risk to life! Never
wash the device directly under run-
ning water or with a hose. This may
give rise to the risk of electrical
shocks.
GB
Suomi
91