Intended Use - schellenberg ROLLODRIVE 55 Bedienungsanleitung

instructed in safe use of the device and know the risks involved. Cleaning and
maintenance must not be carried out by children unless they are supervised�
Children must not be allowed to play with the roller shutter drive.
CE DECLARATION AND CONFORMITY
The belt winder (Item no
ments of European and national regulations. Conformity has been demonstrated.
The full EU Declaration of Conformity document can be found at:
http://www.schellenberg.de (under 'Download-Center', in the 'Service' tab).
Machinery Directive
2006/42/EC
Do not dispose of together with household waste� The product is recyc-
lable and can be deposited at a recycling center or a collection station
for electrical household garbage�

INTENDED USE

This product (Item no�
operation of belt-driven roller shutter systems. For this, the roller shutter system
must comply with the technical requirements of the product�
Any other or further utilization beyond the explicitly specified shall be regarded
as not intended use�
Alfred Schellenberg GmbH shall not be liable for any consequential damage,
property damage and personal injury due to improper use�
According to EN 13659, it must be ensured that the displacement requirements
as per EN 12045 are met for the hanging material� When unrolled, the displace-
ment at the lower edge must be at least 40 mm at an upward-directed force of
150 N� It must be ensured that the travel speed of the hanging must be less than
0�2 m/s in the last 0�4 m�
The roller shutter system and its parts must be in a perfect condition� Defects in
the system or its parts must be repaired before installing the product�
An easily accessible 230 V / 50 Hz mains socket outlet must be available at the
place of installation (see page 218).
The installation surface where the product is to be installed must be level and suitable�
Only use original spare parts to avoid product malfunction or defects�
Improper running of the belt (belt guiding) may destroy the shutter belt and cause
unnecessary strain on the product� Install the product such that the belt enters
the shutter belt drive as vertically as possible� This will avoid unnecessary fric-
tion and wear�
22755, 22725) meets the applicable require-
DE
EMC Directive
2014/42/EU
22755, 22725) is intended exclusively for the
DE
16
RoHS Directive
2011/65/EU