Rack Mounting - LD Systems IMA 120 Bedienungsanleitung

RACK MOUNTING

(Rack mounting kit LDIMARK optionally available)
The optionally available LDIMARK rack-mount kit includes housing adapters and connectors for
fixed installation of IMA 120 or IMA 240 mixer amplifiers (single or two side-by-side) in a 19" rack.
12 11 10
The mounting kit includes the following components:
2 rack adapters with short sides
2 rectangular plates for the bottom
screws for plate .
D
A A
The installation of a single amplifier requires a rack adapter with short side
with long side . Screw the adapter with the short side to the left or right side of the amplifier and
B
the adapter with the long side to the opposite side. Use the M4 flat-head screws for this purpose.
A
If you want to mount two amplifiers side by side in a 19" rack, you will need the two small plates to
connect the amplifiers at the back
and the two rack adapters with short sides
these screws to screw down the panels
the amplifiers with the enclosed M3 countersunk screws, as shown below. Now screw the rack adapters
with the short sides
A
20
9 8
A , 1 rack adapter with long sides
D , 4 M4 pan head screws for the rack brackets, 8 M3 countersunk
, the two rectangular plates to connect them at the bottom
C
A
. Screw the connectors
C
to the sides of the units using the M4 pan head screws.
A
7 6
B , 2 small plates for the back
B
. Loosen the corresponding screws on the back and use
to the designated positions on
D
C
C
5 4 3
C
D
and the rack adapter
A
B
2 1
C ,
D
A