Rack Mounting - LD Systems IMA 30 Bedienungsanleitung

12 11 10

RACK MOUNTING

(rack mounting kit LDIMARK optionally available)
The optionally available rack mounting kit LDIMARK includes rack-mount brackets and connectors for installing a single IMA 30 installation
mixing amplifier, as well as for adjacently installing two amplifiers in a 19" rack. The set includes: 2x rack-mount brackets with short sides
A
, 1x rack-mount bracket with long sides
screws for the rack-mount brackets, 8x M3 countersunk screws for plate
A A
Installing a single amplifier requires a rack-mount bracket with short sides
bracket with the short sides to the left or right side of the amplifier and the bracket with the long side on to the opposite side. Use the
included M4 flat-headed screws for this.
A
To install two amplifiers alongside each other in a 19" rack, you will need the two small plates to join for connecting the amplifiers on the
C
back , the two rectangular plates to join the amplifiers on the bottom
the screws on the back at the corresponding positions and use them to screw on the plates
below, on to the corresponding positions on the amplifiers with the included M3 countersunk screws. Use the M4 flat-headed screws to
screw the rack-mount brackets with the short sides
A
12
9 8 7
B
, 2x small plates for the back
B
A
on to the sides of the devices.
C
C
6 5
C
, 2x rectangular plates for the bottom
D
.
A
and the rack-mount bracket with long sides
B
D
and the two rack-mount brackets with short sides
C
. Screw the connectors
WENN NICHT ANDERS DEFINIERT:
BEMASSUNGEN SIND IN MILLIMETER
OBERFLÄCHENBESCHAFFENHEIT:
TOLERANZEN:
LINEAR:
WINKEL:
GEZEICHNET
GEPRÜFT
GENEHMIGT
PRODUKTION
QUALITÄT
4 3 2
D
, 4x M4 flat-headed
C
D
B
. Screw the
A
. Loosen
D
, as illustrated
A
OBERFLÄCHENGÜTE: ENTGRATEN
ZEICHNUNG NICHT SKALIEREN
UND SCHARFE
KANTEN
BRECHEN
NAME SIGNATUR DATUM BENENNUNG:
NOT SPECIFIED
WERKSTOFF: ZEICHNUNGSNR.
1
ÄNDERUNG