Rack Installation - LD Systems IMA 60 Bedienungsanleitung

RACK INSTALLATION

12 11 10
RACK INSTALLATION
(LDIMARK rack installation kit provided as an option)
The optionally available LDIMARK rank installation kit contains housing adapters and connecting pieces for the permanent installation of IMA 30 or
IMA 60 mixing amplifiers (single or two side by side) in a 19" rack.
The installation kit includes the following components:
2 rack adapters with short sides
4 M4 pan-head screws for the rack brackets, 8 M3 sunkenhead screws for plates
A A
The installation of a single amplifier requires one short-sided rack adapter
short side to either the left or right side of the amplifier and the adapter with the long sides to the opposite side. Use the M4 pan head screws for
this.
A
If you want to install two amplifiers side by side in a 19" rack, you will need the two small plates to connect the amplifiers together at the back
, the two rectangular plates for interconnection at the bottom
on the back and screw the plates down with these screws
the intended positions on the amplifiers, as shown below. Screw the two rack adapters with the short sides
M4 pan-head screws.
A
9 8
A
, 1 rack adapter with long sides
D
and the two rack adapters with short sides
C
. Screw the connecting pieces
7 6
B C
, 2 small plates for the back , 2 rectangular plates for the bottom
D
.
B
A
and the long-sided rack adapter
D
in with the enclosed M3 countersunk head screws to
C
C
5 4 3
C
D
B
. Screw the adapter with the
B
A
. Loosen the corresponding screws
A
to the sides of the device using the
WENN NICHT ANDERS DEFINIERT: OBERFLÄCHENGÜTE:
BEMASSUNGEN SIND IN MILLIMETER
OBERFLÄCHENBESCHAFFENHEIT:
TOLERANZEN:
LINEAR:
WINKEL:
2 1
D
,
C
A
13
ENTGRATEN
ZEICHNUNG NICHT SKALIEREN ÄNDERUNG
UND SCHARFE
KANTEN
BRECHEN