Aux Output; Power Supply - LD Systems IMA 120 Bedienungsanleitung

Item number
Amplifier Output
Type
Amplifier Outputs
Connector
RMS output power
Peak output power
Frequency response
Tone Control
Protection

Aux Output

Connector
Frequency response
Maximum output level

Power Supply

Type
Voltage Range
Mains fuse
Connector
Safety Class
Max power consumption
Idle power consumption
Standby power consuption
Operating Temperature
General
Time to standby
Material
Dimensions (W x H x D)
Weight
Optional Accessories
26
LDIMA120
LO-Z: 4 ohm minimum load, HI-Z 70V or 100V outputs
5-pin Terminal block (pitch 5.08 mm)
125 W (continuous sine wave 1 kHz,
4 ohm load)
135 W (100 msec sine 1 kHz Burst
@ 4 ohm load) Peak Limiter
BASS: +–10 dB (100 Hz), TREBLE: +–10 dB (10 kHz)
Audio Limiter (10 dB range), Over/Undervoltage, Overtemperature, Short-Circuit,
3-pin Terminal block (pitch 5.08 mm)
100 VAC – 240 VAC (+-10%), 50–60 Hz
T4AL 250V
165 W (sine 1 kHz with 4 ohm load)
13 W (no signal input)
0°C – 40°C; < 85% humidity, non condensing
Steel chassis, Plastic Front panel
210 x 95 x 266.76 mm (height with rubber feet)
3.01 kg
Class D
240 W (continuous sine wave 1 kHz,
250 W (100 msec sine 1 kHz Burst
@ 4 ohm load) Peak Limiter
15 Hz – 20 kHz (LO-Z, –3 dB)
60 Hz – 20 kHz (HI-Z, –3 dB)
Offset-Detection
20 Hz – 20 kHz (–3 dB)
22 dBu
SMPS
IEC Jack
Class 1
300 W (sine 1 kHz with 4 ohm load)
15 W (no signal input)
< 1 W
20 min
Rack mounting kit
LDIMA240
4 ohm load)
T6.3AL 250V
3.5 kg