Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Setting Up /
Installation into a Rack
The device can be installed into a rack (482 mm /
19") using the two rack brackets screwed to the
left and right of the device (
rack, one rack unit (1 U = 44 .45 mm) is required .
However, the device can also be set up on
its own without any rack brackets .
4 Connections
4.1 Connections on the rear panel
Antennas
1) For FM and DAB reception, connect a suit-
able antenna to the antenna connector FM
ANTENNA . When the reception conditions
are good, it is also possible to use the wire
antenna provided (
2) Screw the antenna provided for Bluetooth
and Wi-Fi transmission onto the connector
BT/ WLAN ANTENNA (
a vertical position .
Network connection
If the device is not to be integrated into the
local network via wireless connection (wireless
LAN), use the connector LAN to establish a cable
connection to the local network .
RS-232
①
32
☞
fig . 2) . In the
☞
fig . 1) .
☞
fig . 1) and put it in
BT/
WLAN ANTENNA
LAN
RS-232 control connection
For remote control via a computer, the device is
equipped with an RS-232 interface . To use this
option, please refer to chapter 10 .
Audio output and power supply
Before connecting or disconnecting, switch off
all devices involved .
1) Use a cable with RCA plugs to connect the
stereo audio output LINE OUTPUT to the
line level input of an amplifier (input may be
marked: "Line", "Aux", "Tuner" or "CD") .
It is also possible to connect another sub-
sequent device (e . g . active speaker system,
mixer) instead of an amplifier .
2) For power supply, connect the IEC connector
"230 V~ / 50 Hz" to a mains socket using the
mains cable provided .
To ensure continued operation of the de-
vice after a mains failure, connect the screw
terminals "15 V ⎓ " to a 15 V emergency
power supply . When connecting the emer-
gency power supply, observe the polarity!
Note: When ⎓ 15 V is available at the terminals,
the device will be in operation even when the
POWER switch has been set to position
When both the emergency power supply and the
mains power supply are available, the POWER
switch will switch between emergency power
operation (position
sition ) .
LINE OUTPUT
L
FM
ANTENNA
+
15 V
−
R
) and mains operation ( po-
230 V~ /
50 Hz
+
15 V
−
FUSE
USE ONLY WITH A 250V FUSE
("Off") .
23
5
F
Werbung
Inhaltsverzeichnis
