Display Indications When Playing A Dab Station; Operating Mode "Fm Radio - Monacor WAP-204RS Bedienungsanleitung

SELECT to select
Scan
press the knob to start the scan .
Adding a station to the station list manually
A station that is new and offers good reception
can be added to the station list without the need
to perform a station scan again . To do this, it is
necessary to know on which channel the station
is broadcast .
In the "DAB" menu, turn the knob CON-
TROL SELECT to select the menu item
and press the knob to call it up: From
tune
the list of DAB channels, select the channel on
which the corresponding station is broadcast
and call it up . When the channel has been called
up and reception is sufficient (
indication), press the button PREV or NEXT:
All stations of this channel will now be added
to the station list and can be called up from this
list . To go to the station list, press the button
MENU or BACK repeatedly until the menu
is displayed . Then select
call it up .
Saving a station /
Calling up a station that has been saved
Ten stations can be saved for this operating
mode . The procedure for saving a station and
calling up a station that has been saved is the
same as in the operating modes "Internet radio"
and "Podcasts": ☞
tion /podcast" and "Calling up a station /podcast
that has been saved" .
Deleting stations that are not available
Stations on the station list that are currently not
available (marked with a question mark on the
list) can be deleted: In the "DAB" menu, select
the row
Prune invalid
the prompt appears, confirm with
Compressing the dynamic range
For some broadcast programmes, the dynamic
range of audio signals can be compressed:
The volume will be increased for soft sounds
and decreased for loud sounds (suitable for
background music, for example) . In the "DAB"
menu, select (dynamic range control) and
DRC
confirm . The following settings are available:
= high level of compression
DRC hi g h
= low level of compression
DRC low
= no compression
DRC off
in the "DAB" menu and
Manual
☞ bar graph
Station list
chapter 8 .2 "Saving a sta-
and confirm . When
.
YES
The asterisk
Select the desired setting and confirm .
Note: If no compression data is transmitted with the
programme, the DRC setting will not affect the audio
signal .
8.4.1 Display indications when playing a
DAB station
The display will show the station name and in-
formation about the station, the current pro-
gramme or the current music title:
DAB
Station name
Information
The icons at the bottom mean:
stereo mode
DAB
signal strength
and
Press the button INFO repeatedly to show addi-
tional information .

8.5 Operating mode "FM radio"

Press the button MODE repeatedly until
appears . After that, the FM station
FM radio
last listened to will be played, but when the
operating mode is called up for the first time, the
device is set to the first FM receiving frequency .
Station scan / station tuning
To start the scan, press the knob CONTROL
SELECT: The scan will start from the frequency
indicated and will stop at the first station . To
search for the next station, press the knob
again . To change the direction of the scan, first
turn the knob briefly in the desired direction
before starting the scan (to the left: change
to scan downwards; to the right: change to
scan upwards) . Alternatively, the scan can be
performed via the buttons PREV and NEXT :
Keep the button NEXT (upwards) or PREV
(downwards) pressed until the scan starts .
If required, turn the knob to fine-tune a
receiving frequency in steps of 50 kHz .
Saving a station /
Calling up a station that has been saved
Ten stations can be saved for this operating
mode . The procedure for saving a station and
indicates the current setting .
*
19:27
㊸
47