Monacor WAP-204RS Bedienungsanleitung Seite 38

connection to the network will be discon-
nected when it is not required, e . g . during
FM reception or in standby mode (will save
power) . Either confirm
confirm .
Note: When operating the device without any
network connection (as described in step 5A), it is
recommended to select
5) The scan for a network will start:
Network settin g s
Network wizard
Scannin g /
The menu containing a list of all networks
found will appear:
SSID
[WPS]Cafeteria-1
TechDocu
[Rescan]
[Wired]
[Manual confi g ]
A For operation without any network
connection:
Press the button MENU and answer the
confirmation prompt
at next start up?
can now be used for all functions not re-
quiring any network connection .
B For connection to the network via
cable (LAN):
Select
[Wired]
tion to the network will be established:
continue with step 7 .
C For wireless connection to the net-
work (wireless LAN):
Select the name of your network (SSID)
and confirm . If access to your network is
not encrypted, the connection to the net-
work will be established: continue with
step 7 . If access to your network is en-
crypted: continue with step 6 .
Note:
[WPS]
the router supports WPS .
D As an alternative to the methods described
in B and C, manual configuration can
be selected (e . g . if the network name is
38
YES or select
.
NO
⑮
⑯
Run wizard a g ain
as desired . The device
and confirm . The connec-
in front of the name indicates that
not visible or the DHCP function is not
available) .
Note: Manual configuration requires knowl-
NO and edge of network technology .
a) Select
b) Select
on the connection type of the device
and confirm .
c) In the next menu, select
and confirm if the router automatically
transmits the network settings to the
device via DHCP . If the DHCP function
on the router has been deactivated
or is not available, select and confirm
DHCP disable
for IP address, subnet mask, gateway
address and DNS in the menus that
follow .
In case of cable connection to the net-
work, the network connection will be
established when the last setting has
been confirmed, continue with step 7 .
In case of wireless connection, continue
with step d .
d) The menu for entering the network
name will appear:
SSID
0123456789._- ,
opqrstuvwxyzABC
DEFGHIJKLMNOPQR
Enter and confirm the network name
(for using the input menu see descrip-
tion underneath fig . 18) .
e) In the next two menus, set the encryp-
tion method used by the router .
6) If access to the network is encrypted, a menu
for entering the network key will appear
(if the WPS menu shown in fig . 19 appears in-
stead, continue as described in that section):
Key:
0123456789._- ,
abcdef g hijklmn
opqrstuvwxyzABC
DEFGHIJKLMNOPQR
To select the characters and the three com-
mand buttons, turn the knob CONTROL
SELECT and press the knob to confirm .
[Manual confi g ]
or
Wired Wireless
and make the settings
abcdefghijklmn
BKSP
OK
CANCEL
and confirm .
depending
DHCP enable
6/9
BKSP
OK
⑰
CANCEL
⑱