Display Indications When Playing An Fm Station; Operating Mode "Bluetooth - Monacor WAP-204RS Bedienungsanleitung

calling up a station that has been saved is the
same as in the operating modes "Internet radio"
and "Podcasts":
tion /podcast" and "Calling up a station /podcast
that has been saved" .
Changing the scan setting
The station scan is set in the factory in such a
way that it will only stop for stations with good
reception . To stop the scan also for stations with
poor reception, press the button MENU . The
menu will appear:
FM
FM
Scan settin g
Audio settin g
System settin g s
Main menu
Scan settin g
CONTROL SELECT . The following confirmation
prompt will appear:
FM station scan
Stron g stations only?
YES*
Turn the knob CONTROL SELECT to select
and press the knob to confirm .
Mono mode
To reduce the noise from stations with poor
reception, select the mono mode: Press the but-
ton MENU . The menu
Select
Audio settin g
ing confirmation prompt will appear:
FM weak reception
Listen in Mono only?
YES
Select the setting
will be reproduced in mono .
8.5.1 Display indications when playing an
FM station
If the station broadcasts RDS information, the
display will show the station name instead of
the frequency (may take a few minutes) . Some
stations also give information about the pro-
gramme and /or the current music title .
48
chapter 8 .2 "Saving a sta-
☞
>
>
>
㊹
is selected . Press the knob
㊺
NO
will appear (fig . 44) .
FM
and confirm . The follow-
㊻
NO*
and confirm . All stations
YES
FM
Station name
Information
The icons at the bottom mean:
RDS (Radio Data System)
R . D . S
= transmission of additional information
stereo mode
signal strength
Press the button INFO repeatedly to show addi-
tional information .

8.6 Operating mode "Bluetooth"

In "Bluetooth" mode, audio data can be trans-
mitted wirelessly from an audio source using
Bluetooth transmission (e . g . smartphone) to
WAP-204RS . Press the button MODE repeatedly
until
Bluetooth Audio
the display will show:
Bluetooth
Bluetooth Discover
Please connect with a
device to :
Multi Tuner
NO
Setting up the Bluetooth connection
1) Activate the Bluetooth function on the
Bluetooth source . On the list of available
devices, WAP-204RS will appear under the
name „Multi Tuner", followed by a combi-
nation of characters .
2) Pair the Bluetooth source with "Multi Tuner . . ."
(if necessary, consult the instructions for the
Bluetooth source) . The message
will briefly appear, followed by the start dis-
play for the Bluetooth source, e . g .:
Bluetooth
0:00
The Bluetooth icon
display stops flashing, indicating that a Blue-
tooth connection has been established . The
stop icon
made at the moment .
12:45
㊼
R . D . S
is displayed . After that,
09:33
㊽
09:34
0:00
㊾
at the bottom of the
indicates that no replay is being
Connected