INSTALLATION
13.2. Connecting a compressor installed in a cabinet
Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors. (Fig. 12)
Connect the cabinet electrically to the compressor by inserting the provided power cordwith
connector into an outlet. (Fig. 13)
Disconnect the cabinet electrically from the compressor by pulling the connector from the outlet
while the latch is released.
Connect the display at the front door of the cabinet and then secure the cord to the display in the
clamps (1). Secure the cord for DK50 4VR/50 S/M compressors in the clamp (1) in the cabinet
door (Fig. 18). Secure the cord for DK50 2x4VR/110 S/M compressors in the clamps (1) in the
cabinet enclosure (Fig. 22).
Fig. 12: Opening in the rear wall of the cabinet
Fig. 13: Connect the cabinet to the compressor
14. PLACEMENT OF THE COMPRESSOR IN THE CABINET
14.1. DK50 4VR/50 S/M (Fig. 4-A):
Disassembly cabinet door
Remove the door held by 2 screws and disconnect the display connector and the earthing lead.
03/2022
39
NP-DK50 4VR 50, DK50 2x4VR 110-AD-1_03-2022