Installation; Placement Of The Compressor - EKOM DK50 2V50 Anleitung Zur Installation, Bedienung Und Wartung

DK50 2V/50

9. INSTALLATION

Only qualified personnel can install and start up
personnel in its correct use and maintenance. Installation and training of all operators
shall be confirmed by the installer's signature on the certificate of installation.
Prior to installation, ensure that the compressor is free of all transport packaging and
stabilizers to avoid any risk of damage to the product.

Caution! When in operation, the compressor is hot. Burns or fire may result if contact is

made by the operator or any flammable material.
Electric cord for connection to electric mains and air hoses may not be broken. The power
cord may not be exposed to pulling, pressure and excessive heat.
9.1.

Placement of the compressor

Handling
Fig.4 Unpacking
Dental compressor DK50 2V/50, DK50 2V/50/M
(Fig.4)
After removing all packaging material, place the product on the floor and remove stabilization parts Y (Detail
A). Connect output hose with end-piece to the appliance. Plug the mains cord plug into a socket.
Dental compressor in box DK50 2V/50S (Fig.3, Fig.4)
After unpacking, place the product onto the floor in a room, release it from packaging materials and remove
fixation parts (Y) - detail A. Place a wall end stop (21) 2 pcs on compressor casing in the rear, upper part of
the casing and fit in the casing on the required place.The end-stops shall ensure the sufficient distance of the
casing from the wall for thorough ventilation. For fitting the compressor in the place to the casing it is
necessary to disassemble the casing door and take off the connecting reinforcement (28) in the front bottom
part of the casing. Protrude the pressure hose under the casing and fix it to the appliance in a suitable
manner. Grasp the compressor at its handle and using the transport mechanism (20) and the built-in
castors (15) place it to the casing. Embed the hose (27) of manometer (25) of the casing to fast-on coupling
on the compressor, place back the connecting reinforcement (28) and connect output pressure hose to the
compressor.
Connect the connector (26) of casing to the compressor and connect the electric mains plug to mains socket.
10/2015
the appliance and train operating
- 9 - NP-DK50 2V50-6_10-2015 MD