Before Starting The Machine; Unpacking; General Notes; Assembly - Scheppach DECO-XLS Original Bedienungsanleitung

• Adopt your way of working to the equipment.
• Do not overload the equipment.
• Have the equipment checked if necessary.
• Switch off the equipment when not in use.
Suitable saw blades
All industry-standard saw blades with a minimum
length of 127 mm with and without a pin may be used.
7.

Before starting the machine

7.1 Unpacking

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!

7.2 General notes

• All covers and safety devices have to be properly
fitted before the equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
equipment's moving parts run smoothly.
• Check that the voltage on the rating plate is the
same as your supply voltage before you connect the
equipment to the power supply.
• Only ever connect the equipment to a properly in-
stalled shock-proof socket which is protected by a
10A fuse as a minimum.
30 | GB
7.3 Installing the fretsaw on a workbench
Required for installing:
Included in the scope of delivery:
• M8 hexagonal bolt (4x)
• M8 hexagonal nut (4x)
• Washer Ø 9 mm (8x)
The length of the screws to be used varies, depending
on the thickness of the table top.
WARNING
Danger of injury! Disconnect the mains plug on the
scroll saw before all assembly work.
1. The length of the screws to be used varies, de-
pending on the thickness of the table top.
2. Mark the drill holes (see fig. 5.2).
3. Drill 4 holes with a diameter of 8 mm into the work
table.
4. Screw the scroll saw onto the workbench with the
hexagonal bolt (E) through the assembly points
(fig. 3 pos. 19) in the following sequence (fig. 5.1):
A Fretsaw
B Work table
C Washer
D Hexagonal nut
5. Tighten the hexagonal nut (D) first.

8. Assembly

WARNING
Danger of injury! Disconnect the mains plug on the
scroll saw before all assembly work.
8.1 Fitting / Replacing the saw blade (fig. 1, 8-11)
IMPORTANT
To avoid injuries attributed to inadvertent startup: Be-
fore removing or replacing the saw blade, always press
"0" and remove the mains plug from the socket.
8.1.1 Removing the saw blade without pins (option-
al)
1. To remove the saw blade (22) , lift the table insert
(26) upwards.
2. First, release the tension by flipping the tension
lever (11) upwards. Continue reducing the tension
by turning clockwise as required.
3. Press the support (12) down lightly (see fig. 9).
www.scheppach.com