Technical Data; Machine Description - Scheppach Basa 5.0 Originalanleitung

Band saw
Sawband 15mm
Fence
Suction connectio piece, 100 mm diam
Push stick
Length/width/height mm ....................................................................................................... 100x900x1850
Bench size mm ............................................................................................................................... 640x640
Working height mm ................................................................................................................................. 900
Sawband mm ........................................................................................................................... 15x0,5x3430
Band wheel diameter mm ....................................................................................................................... 450
Cutting height at 90° mm ........................................................................................................................ 300
Clearance width mm .............................................................................................................................. 440
Parallel cutting width mm ....................................................................................................................... 300
Parallel stop length mm .......................................................................................................................... 650
Bench swing range mm ...................................................................................................degrees -20°/+47°
Cutting speed with 2 switching levels m/min ................................................................................ 800/1200
Weight kg ................................................................................................................................................ 190
Motor
Consumption P1 (kW)
Output P2 (kW)
Noise parameters
The noise emission values determined according to
EN 23746 for the sound level and according to EN
31202 (coefficient of correction k3 calculated ac-
cording to Appendix A.2 of EN 31204) for the sound
level at the workplace are as follows, based on the
working conditions listed in ISO 7904 Appendix A:
Due to its perfected design, the machine offers a
versatile application for processing wood and plas-
tics in the workshop.
The upper and lower bandwheel is protected by a
fixed guard and an articulated cover. Upon opening
the cover, the machine is switched off. Switching on
again is only possible with the cover closed. The
non-cutting part of the sawbelt above the table top
is covered by a guard fixed to the sawbelt guide,
the latter being protected against inadvertant ope-
ning by the fixed guard of the upper band wheel.
The non-cutting part of the sawbelt under the table
Supply volume

Technical Data

230 V / 50 Hz
2,30
1,50

Machine description

GB
Assembly accessories
Operating instructions
Sound level at the workplace in dB
Idle running LpAeq = 64 dB(A)
Operation LpAeq = 85 dB(A)
A measurement uncertainty allowance K = 4 dB
applies to the mentioned emission values.
top is protected by a fixed cover.
The swivelling range of the table from -20° to +47°
allows versatile cutting possibilities (e.g.)
• Longitudinal cuts
• Crosscuts
• Diagonal cuts
• Curved and irregular cuts
• Cuts for dovetails and tenons
• On-edge cuts of squared beams
Please consult also the working hints in the opera-
ting instructions
400 V / 50 Hz
2,90
2,20
GB