Automatic Programmes - Silvercrest SDI 3500 D4 Bedienungsanleitung

Automatic programmes

Boost
Use the "Boost" programme to speed up the cooking process.
1) Press the "Boost" button
The appliance will switch to the highest output level for around 30 sec-
onds. The display t shows the maximum power level for the active
induction field 1/3. The Boost control lamp
2) To cancel the programme prematurely, press the "Boost" button
Otherwise, the appliance will automatically revert to the previous power or tem-
perature level after 30 seconds. The Boost control lamp
Milk
Use the "Milk" programme to heat milk without it boiling over. The milk is heated
to around 60°C at a low power level and kept at that temperature for around
20 minutes.
1) Press the "Milk" button
The Milk control lamp
NOTE
► You can activate the "Boost" programme at the same time. The "Milk" pro-
gramme is stopped for about 30 seconds and then resumed afterwards.
► If you activate the "Keep warm" programme at the same time, the "Milk"
programme will be cancelled.
2) Press the Mode button
normal operation.
Keep warm
The "Keep warm" programme keeps the content of the pan at around 60°C for
2 hours. The appliance will switch off the respective induction field 1/3 as
soon as it reaches 60°C. If the temperature falls below 60°C, the appliance
will heat up again.
1) Press the Keep warm button
The display t now alternates between the temperature
ing time until the end of the programme, starting at
control lamp
SDI 3500 D4
s lights up. The display t now alternates between
and the remaining time until the end of the programme, starting at
9 lights up.
i while cooking.
u during operation.
e to stop the "Milk" programme and return to
w during operation.
a lights up.
i again.
a will switch off.
and the remain-
. The Keep warm
GB │ IE
.
│ 13 ■