Start Up - Scheppach SG7100x Original Bedienungsanleitung

Installing the transport wheel (fig. 3)
1. Feed the wheel axle (D) through the wheel (19).
2. Now push the washer onto the wheel axle (D) and
slide the wheel axle (D) with the wheel (19) into
the hole of the lug (a).
3. Secure the wheel axle each with a spring split
pin (F)
Installing the support feet (fig. 4)
1. Fit the support feet (11) to the lower frame strut.
Fix the support feet with two nuts each (B).
Installing the transport handle (fig. 5)
With the pin (A) you can fix the handle (10) in position
Connecting the battery (Fig. 6)
Connect the red cable to the plus pole (+) and the
black cable to the minus pole (-).
Note: The battery charges itself during operation.
Attention! Fill the oil before first use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest
quality four-stroke oil or an HD oil with the same level
of quality.
Checking the oil level
Remove the oil filler cap with dipstick (14) and wipe
the dipstick clean. Check the oil level by inserting the
dipstick into the filling nozzle without screwing the cap
on. If the oil level is too low, refill with the recommended
oil up to the lower rim of the oil filling nozzle.
Oil warning system
The oil warning system is configured to avoid damage
to the engine due to a lack of oil in the spherical
housing. Before the oil level in the spherical housing
can drop below the safety level, the oil warning system
automatically cuts the engine off. If the oil warning
system cuts the engine off, refill the engine oil.
Refuelling
Warning! Petrol is highly inflammable and explosive.
When handling fuels, you may suffer burns or other
severe injuries. Use petrol with an octane rating of at
least 95 octane. Only use fresh, clean fuel. Water or
impurities in the petrol damage the fuel system.
Tank volume: 25 litres
• Only fill the tank up to the marking in the fuel
strainer.
• Note that fuel expands.
24 | GB
• Refuel in a well-ventilated area with the engine
stopped. If the engine was in operation immediately
before, allow it to cool first.
• Never refuel the engine in a building where the
petrol vapour may come into contact with flames
or sparks.
• Do not smoke whilst refuelling or in the area in
which the petrol is stored and prevent naked flames
or sparks under these circumstances.
• After refuelling, ensure that the tank cover is closed
correctly and securely again. Take care!
• Mop up spilled petrol immediately.
• If petrol is spilled, ensure that the area is dried
before starting the engine.
• Avoid repeated or long contact of the fuel with the
skin and avoid breathing in the fumes.
• Keep the fuel out of the reach of children.
• If there are occasional taps or knocks from the
engine, you should use a different brand of petrol.
If this does not solve the problem, contact an
authorised dealer.
WARNING: Operating the engine with continuous
ignition tapping or knocking can result in damage
to the engine. Operating the engine with continuous
ignition tapping or knocking is considered improper
use. The manufacturer is not responsible for the
resulting damages; the user solely bears the risk.
9.

Start up

Earthing the generator
Earthing the housing is possible to discharge static
charging. To do this, connect a cable on one side to
the earth terminal (12) of the power generator and on
the other side to an external mass rising pipe (e.g.
rod earth).
WARNING: Do not use any pipes that carry
inflammable substances as an earth source.
Starting the engine (Fig. 1 + 7)
NOTE: Do not connect the electrical device before
starting the engine.
1. Turn the fuel valve key (7) to "ON".
When the engine is cold:
Move the choke lever (6) to the CLOSED position by
moving the lever to the left.
Return the choke lever (6) to the OPEN position while
the engine warms up.
www.scheppach.com