Start Up - Scheppach SG3200 Serie Original Bedienungsanleitung

Installing the support feet (fig. 4)
1. Fit the support feet (14) to the lower frame strut.
Fasten the support feet with a bolt and nut (F)
each.
Installing the transport handle (fig. 5 + 6)
1. Fix the handle holder (b) to the upper frame (19)
with the screws and nuts (E).
2. Then align the transport handle (8) in the handle
holder (b) and fix it with a bolt and nut (E).
Attention! Do not overtighten the screw (E) for the
handle (8), the handle (8) must be able to move freely.
Attention! Fill the oil before first use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest
quality four-stroke oil or an HD oil with the same level
of quality.
Checking the oil level
Remove the oil filler cap with dipstick (10) and wipe the
dipstick clean. Check the oil level by inserting the dip-
stick into the filling nozzle without screwing the cap on.
If the oil level is too low, refill with the recommended oil
up to the lower rim of the oil filling nozzle.
Oil warning system
The oil warning system is configured to avoid dam-
age to the engine due to a lack of oil in the spherical
housing. Before the oil level in the spherical housing
can drop below the safety level, the oil warning system
automatically cuts the engine off. If the oil warning
system cuts the engine off, refill the engine oil.
Refuelling
Warning! Petrol is highly inflammable and explosive.
When handling fuels, you may suffer burns or other
severe injuries. Use petrol with an octane rating of at
least 92 octane. Only use fresh, clean fuel. Water or
impurities in the petrol damage the fuel system.
Tank volume:15 litres
• Only fill the tank up to the marking in the fuel strain-
er.
• Note that fuel expands.
• Refuel in a well-ventilated area with the engine
stopped. If the engine was in operation immediately
before, allow it to cool first.
• Never refuel the engine in a building where the
petrol vapour may come into contact with flames
or sparks.
24 | GB
• Do not smoke whilst refuelling or in the area in
which the petrol is stored and prevent naked flames
or sparks under these circumstances.
• After refuelling, ensure that the tank cover is closed
correctly and securely again. Take care!
• Mop up spilled petrol immediately.
• If petrol is spilled, ensure that the area is dried be-
fore starting the engine.
• Avoid repeated or long contact of the fuel with the
skin and avoid breathing in the fumes.
• Keep the fuel out of the reach of children.
• If there are occasional taps or knocks from the en-
gine, you should use a different brand of petrol. If
this does not solve the problem, contact an author-
ised dealer.
WARNING:Operating the engine with continuous igni-
tion tapping or knocking can result in damage to the
engine. Operating the engine with continuous ignition
tapping or knocking is considered improper use. The
manufacturer is not responsible for the resulting dam-
ages; the user solely bears the risk.
9.

Start up

Earthing the generator
Earthing the housing is possible to discharge static
charging. To do this, connect a cable on one side to
the earth terminal (12) of the power generator and on
the other side to an external mass rising pipe (e.g.
rod earth).
WARNING:Do not use any pipes that carry inflam-
mable substances as an earth source.
Starting the engine (Fig. 1 + 7)
NOTE:Do not connect the electrical device before
starting the engine.
1. Turn the fuel valve key (3) to "ON".
When the engine is cold:
Move the choke lever (3) to the CLOSED position by
moving the lever to the left.
When the engine is warm:
Move the choke lever (6) to the OPEN position by mov-
ing the lever to the right.
2. Set the on/off switch (9) to the ON position
3. Pull the recoil starter (6) slowly until resistance is
noticeable. Then pull hard.
www.scheppach.com