Unpacking; Before Starting Up - Scheppach PRACTIXX PX-SE-2000 Originalbetriebsanleitung

Information concerning noise emission measured ac-
cording to relevant standards:
Sound pressure L = 71,6 dB(A)
pA
Sound power L = 91,6 dB(A)
wA
Uncertainty K = 1,13 dB
pA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
7.

Unpacking

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised. If possible, store the packaging until the
warranty period has expired.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
Danger of swallowing and choking! Packaging ma-
terial, packaging and transport safety devices are
not toys for children. Plastic bags, foils and small
parts can be swallowed and cause suffocation.
Keep packaging material, packaging and transport
safety devices away from children.

8. Before starting up

m ATTENTION!
Always check before starting the engine:
• Check the fuel level and top it up if necessary - the
tank should be at least half filled
• Make sure that the generator has sufficient ventila-
tion
• Make sure that the ignition cable is secured to the
spark plug
• Disconnect possibly connected electronical device
from the generator
• Condition of the air filter
26 | GB
• Condition of the fuel lines
• The external bolt connections for tightness
Attention! Fill the oil before first use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest
quality four-stroke oil or an HD oil with the same level
of quality.
SAE 10W-30 is recommended for general use at all
temperatures.
Checking the oil level, fig. 6
Remove the engine cover (Fig. 5)
Remove the oil filler cap (A) and wipe the dipstick
clean.
Check the oil level by inserting the dipstick into the fill-
ing nozzle without screwing the cap on.
If the oil level is too low, refill with the recommended oil
up to the lower rim of the oil filling nozzle.
Filling with fuel
• To refuel - cap (2) open counter clockwise.
• Fill fuel tank in
• Closing tank - tank cap (2) clockwise.
Recommended fuel
Unleaded regular gasoline with a research octane
number of 91 or higher is required for this engine.
Use only fresh and clean fuel.
m Water or impurities in the petrol damage the fuel
system.
Tank volume: 4,1 litre
m Refuel in a well-ventilated area with the stopped
engine. If the engine has been running, allow it to
cool first. Never refuel the engine inside a building
where gasoline fumes may reach flames or sparks.
Petrol is highly flammable and explosive. You can
get burns or other serious injuries when handling
fuel.
• Switch off the engine and keep it away from heat,
sparks and flames.
• Refuelling only outdoors.
• Immediately clean up spilled petrol.
www.practixx.com