Herunterladen Diese Seite drucken

Tunze Comline Reefpack 500 Gebrauchsanleitung Seite 13

Vorschau ausblenden Andere Handbücher für Comline Reefpack 500:

Werbung

Selecting the position
Attach Comline Reefpack in a corner of the aquarium
in such a way that it can be operated easily (1).
- There should be enough free space above the filter
system in order to be able to remove the filter bell
or the skimmer cup vertically from the filter without
hitting instead of knocking the frame of the lamps.
- Select the position of the storage container. Then
determine the length of the hose from the Osmolator.
Shorten the hose only, when you are certain that the
filter will not be moved again.
- The water level in the aquarium always has to be
above the water level in the storage container.
- In order to fit the filter system at any position in the
tank easily, we recommend the use of the Magnet
Holder 6080.50 up to a glass thickness of 12 mm
(.47 in.) or Magnet Holder 6200.50 up to a glass
thickness of 19 mm (.74 in.) (two units per
Reefpack).
Selecting the position for Controller 5017
- The wall has to be dry; do not select position above
the aquarium !
- Lay the cables in such a way that no water can run
along and get into the controller (2) !
Placement
Placez Comline Reefpack 500 dans un angle de
l'aquarium et de manière à permettre un bon confort
d'utilisation (1).
- l'espace au-dessus de la filtration doit être assez
dégagé pour permettre une extraction facile de la
cloche de filtration et du godet d'écumeur sans
toucher l'appareillage d'éclairage
- évaluez la longueur du tuyau d'Osmolator puis
coupez uniquement à longueur lorsque le
placement des appareillages est définitif
- le niveau d'eau de l'aquarium doit toujours se situer
au-dessus du niveau du réservoir d'Osmolator
- pour une fixation facile et pratique de la filtration
Comline Reefpack 500 à n'importe quel endroit de
l'aquarium, nous conseillons l'utilisation de Magnet
Holder 6080.50 jusqu'à 12mm d'épaisseur de
verre et 6200.50 jusqu'à 19mm (2 ensembles par
Reefpack 500)
Placement du Controller 5017 :
- la surface doit être propre et sèche, n'utilisez pas
un emplacement au-dessus de l'aquarium !
- positionnez les câbles de telle manière à ce que
la pénétration de l'eau dans le boîtier soit
impossible ! (2)
13

Werbung

loading