Replacing The Filter Pad; Replacing The Strap - Abicor Binzel FEC Originalbetriebsanleitung

9 Maintenance and cleaning

9.5 Replacing the filter pad

Fig. 5
A Housing
B Filter pad
C Cover grille
Place a protective underlay (E) (fleece, cardboard, blanket, or similar) on the floor. Ensure it is large
1
enough for the area you want to protect.
Place the device with the rear side (F) on the protective underlay (E).
2
Loosen the mounting screws (D) of the cover grille (C) with an Allen key AF5.
3
Remove the cover grille (C).
4
Remove the filter pad (B).
5
Dispose of the filter pad (B) in accordance with local regulations.
6
Insert the new filter pad and install the cover grille with a tightening torque of 7 Nm.
7
Insert the mounting screws (D).
8
Tighten the mounting screws (D) with an AF5 Allen key.
9
Set the device upright.
10
Remove the protective underlay (E).
11

9.6 Replacing the strap

Loosen the screw on the latch with an Allen key and remove it.
1
Remove the latch.
2
Remove the strap.
3
Insert the new strap.
4
Replace the latch.
5
Insert the screw and tighten it with an Allen key.
6
EN - 22
Replacing the filter pad
F
D 4× mounting screws
E Protective underlay
F Rear of device
E
FEC
A
B
C
D